The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE MR 3863 - 2g (rear window heating repair kit)

No.

IDH.1151364

LOCTITE MR 3863 - 2g (rear window heating repair kit)

LOCTITE MR 3863 - 2g (rear window heating repair kit) (IDH.1151364)

Product description:
LOCTITE 3863 Circuit+ is a complete, fast and easy to use repair kit for rear windscreen defoggers. It has high conductivity due to its high silver content. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Find the malfunctioning section of heating circuit (e.g. with a multimeter to test for electrical continuity).
2. Disconnect the heating circuit from the source of electricity.
3. Clean area to be repaired with LOCTITE SF 7063.
4. Remove protective film from the mask/stencil provided. After use, the protective film can be put back on the mask/stencil.
5. Put the stencil on the area to be repaired. The hole in the stencil has to be in line with the heating wire. Press stencil onto screen.
6. Shake bottle before use.
7. Apply the liquid in the stencil opening with the brush provided. The complete area to be repaired needs to be covered. Leave to dry for 5 minutes.
8. Repeat after 5 minutes. Apply a minimum of 3 layers.
9. Firmly close bottle after use and clean brush.
10. The stencil should not be removed until 30 minutes after last application. Remove carefully.
11. The heating circuit can be connected to the power source after 24 hours.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Appearance : silver liquid
  • Specific Gravity at 25 °C : 0.965

    Full technical information can be found in the technical data sheet.
  • Assortment