LOCTITE MR 5972 - 200g (slow drying viscous sealant, -45 °C to 315 °C, gray paste)
No.
IDH.142273
LOCTITE MR 5972 - 200g (slow drying viscous sealant, -45 °C to 315 °C, gray paste)
Product description:
LOCTITE MR 5972 is a slow drying viscous paste. It remains pliable and flexible and is designed to seal flanges, threaded connections and fasteners at temperatures from -45 °C to +315 °C. It can be effectively applied to cork, paper, plastic and metal surfaces. Typical applications include sealing gaskets, flanges and threaded connections, aircraft heating systems, manifolds, pipe fittings, steam lines, gear boxes and cover plates. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. Clean and dry all surfaces. Use LOCTITE SF 7063.
2. Apply LOCTITE MR 5972 onto both surfaces and spread with spatula or putty knife.
3. Assemble parts immediately while still wet. Secure or tighten to recommended torque specifications.
4. Allow 3 to 5 hours before using equipment.
5. Re-torque will not be necessary after the product has cured.
Storage:
Store product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet.
LOCTITE MR 5972 is a slow drying viscous paste. It remains pliable and flexible and is designed to seal flanges, threaded connections and fasteners at temperatures from -45 °C to +315 °C. It can be effectively applied to cork, paper, plastic and metal surfaces. Typical applications include sealing gaskets, flanges and threaded connections, aircraft heating systems, manifolds, pipe fittings, steam lines, gear boxes and cover plates. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. Clean and dry all surfaces. Use LOCTITE SF 7063.
2. Apply LOCTITE MR 5972 onto both surfaces and spread with spatula or putty knife.
3. Assemble parts immediately while still wet. Secure or tighten to recommended torque specifications.
4. Allow 3 to 5 hours before using equipment.
5. Re-torque will not be necessary after the product has cured.
Storage:
Store product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Resistant to petrol, oils and cooling agents
- Working temperature : from -45 °C to +315 °C
- Seals pressures : up to 34 MPa
- Color : black paste
- Specific gravity : 1,1
- Viscosity : consistency similar to SAE 60 engine oil
Full technical information can be found in the technical data sheet.
