The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE AA 3342 - 300ml (acrylic adhesive, up to 180 °C)

LOCTITE AA 3342 - 300ml (acrylic adhesive, up to 180 °C) (IDH.537444)

Product description:
LOCTITE AA 3342 is designed primarily to provide fast fixture speed on activated surfaces. The product has the capability to provide high tensile strength while maintaining tough durable bonds with excellent impact and high temperature resistance. Typical applications include structural bonding of small rigid parts of dissimilar materials. Particularly suited for applications where excellent impact and heat resistance is required, e.g. bonding ferrites into motor cans. Automated assembly lines with short cycle times will benefit from the rapid cure charecteristics of LOCTITE AA 3342. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. To ensure a fast and reliable cure, activator should be applied to one of the bond surfaces and the adhesive to the other surface.
3. The recommended bondline gap is 0.1 mm. Where bond gaps are large (up to a maximum of 0.5 mm), or faster cure speed is required, activator should be applied to both surfaces.
4. Parts should be assembled immediately (within 15 minutes).
5. Excess adhesive can be wiped away with organic solvent.
6. Bond should be held clamped until adhesive has fixtured.
7. Product should be allowed to develop full strength before subjecting to any service loads (typically 24 to 72 hours after assembly, depending on bond gap, materials and ambient conditions).

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
Shear strength, ISO 4587 ( after 24 hours in 25 °C ):
  • Steel (shot-blasted), with activator 7380 1 side, gap 0 mm, N/mm² : ≥12
  • Steel (shot-blasted), with activator 7380 1 side, gap 0,5 mm, N/mm² : ≥10
Shear strength, ISO 4587 (after 72 hours in 22 °C):
  • Steel (shot-blasted), with activator 7380 1 side, N/mm² : 15 to 29
  • Zinc dichromate, N/mm² : 10 do 18
  • Aluminum, N/mm² : 7 to 21
  • Stainless steel, N/mm² : 10 to 18
Tensile strength, ISO 6922:
  • Steel shaft, N/mm² : 4 to 12

Full technical information can be found in the technical data sheet.

Assortment